Tiles Installation & Maintenance



TILES INSTALLATION
  • The surface must be clean, smooth, dry and free of wax and grease. Areas that are damaged or uneven must be patched and levelled.

  • Layout marks the centre point of all four walls. First of all, layout the tiles to minimize the number of cut tiles.

  • When laying tiles, bear in mind that variation of shade is an inherent characteristic of porcelain tiles, mixing well between several cartons and giving a total blend and random effect. It is advised to use the same calibre when tiling on the same area.

  • Use tile spacers for each tile setting, to leave equal joint between tiles. We recommend a tiling gap of 3mm.

  • The settling time will vary from a few hours to few days and depending on the type of material or adhesive used for installation. During grouting, remove the tile spacer and spread grout on the tile surface using a rubber grout float or squeegee. It is important for you to refer to the adhesive package for specific instructions or precautions.

  • Remove excess grout from surface immediately after grouting. Wait for a couple of minutes, depending of the specific instructions and then remove the excess grout from surface with damp sponge, clean grout residue and smooth the grout joints.

HOW TO MAINTAIN TILES

General maintenance and cleaning of Niro Granite, the Swiss-quality tiles will vary depending on the surface texture and soil load.

Generally, the cleaning should be performed by;




Sweeping or vacuuming to remove loose soil, sand or dirt contaminants


Use damp mop with clean water.


Depending on the soil load, extra cleaning process may be required by using a neutral cleaner or a general household cleaner then followed by a thorough rinse.





There are five critical steps and should always be remembered for the successful maintenance of porcelain tiles;



STEP 1
All spills be cleaned as quickly as possible.
STEP 2
Use only the recommended detergent and the dillution proportions advised.
STEP 3
Allow proper dwelling of the detergent solution to act on the soil load. Generally, 5 to 10 minutes is sufficient.
STEP 4
Scrub with a nylon pad or bristle brush.
STEP 5
Rinse thoroughly with clean, clear water to remove the dirty detergent solution and emulsified soil.

Rinsing is a critical step in the maintenance procedure. Use a wet vacuum, dry mop or towelling if necessary. If dirty detergent solution is not removed and is allowed to dry on the surface, a coating will form which is very difficult to remove.

Table below shows the type of cleaning products recommended.



Types Stains Types of Cleaning Product Recommended
Food Category Ice Cream
Ketchup
Soy sauce
Coffee/Tea
Juices
Coke
Alkaline base detergent
Oil & Grease Vegetables
Minerals
Petrol
Alkaline base detergent
Wax
Rubber
Scrap off, then use solvent turpentine follow by alkaline base detergent
Lip stick
Shoe polish
Alkaline base detergent
Paint (oil based) Turpentine or thinner
Ink Solvent such as turpentine
Mortar Acidic base detergent
Rust stain Diluted hydrochloride acid or acidic base detergent
Market Felt pen Thinner
Methylene blue Alkaline base detergent
Crayon Scrape off then use turpentine follow by alkaline base detergent
Tile Grout Cement Diluted hydrochloride acid
Latex or polymer Solvent such as turpentine or thinner
Epoxy Scraper to scrape it off